![]() ![]() Besure the fuel shutoff valve in in the closed position, and use a flare nutwrench to remove the flare fitting at the elbow without damaging it. Eachof these shafts terminate in a spring loaded socket that will release the ballon the carburetor throttle shaft or choke shaft when the endcap is pulledagainst the spring.A rigid steel fuel line connects to the carburetor fuel strainer elbow. There are two linkage shafts that connect to thecarburetor, one to the governor and one to the choke control on the dash. It includes a replacement throttle shaft, new butterflyvalve screws, fuel inlet filter, new float needle and seat, new float pin andgaskets.The rebuild kits are manufactured by TISCO (BK45V) and are available fromtractor supply houses that sponsor Yesterday's Tractors 8N,and also manufactured by Sorenson and carried on special order by AutoZone andthe like.How you remove the carburetor from your tractor will depend on yourparticular model/year. Related Sites Submitted ArticleStep-by-Step Carburetor Overhaul1952 Ford 8Nby Don Stewart The carburetor kit for the TSX-241A/B/C carburetor is being supplied in onlyone flavor nowadays. Use a Remote Fuel Primer Bulb System to Start a Cold Engine - A proven, ingenious, thoroughly researched and innovative concept by Brian Miller, because nobody else advertise the use of this system for use on a lawn and garden tractor or small motorized vehicle.
0 Comments
Leave a Reply. |